26
106205_06_07_08
Revision date: 08.30.18
Complete the following general steps to install end panels.
1. Consult panel location diagrams and select a panel. Example shows installing panel above
door first. See A in diagram at right for first panel.
2. Measure frame opening that panel will cover to determine panel size and cut panel as
needed.
Panel above door: Measure width to center of each frame member.
ATTENTION:
Remove protective film, mark UV-protected side with piece of tape, and apply
vent tape to panel bottom.
3. Take a piece of 113236Z096 aluminum H-channel and cut to needed length. For panel above
door, cut a piece for each edge.
NOTE:
Review panel layout diagram in Quick Start section to best understand where to
install the different aluminum profiles. When attaching any aluminum profile, remember to
account for areas where different sections of profile (U-channel, end cap, and H-channel)
intersect so you cut profile to proper length.
Determine how you want these profiles to intersect and install as needed to achieve the
desired, uniform, and finished look.
4. Space FA4484B Tek screws
evenly at 16" on-center
when securing panels. DO NOT USE
WASHERS WHEN SECURING H-CHANNEL TO END FRAME.
ATTENTION:
Install 104213 U-channel on bottom of outer panels prior to installation.
Use diagram (lower right) when attaching
panels and H-channel to frame. Install
H-channel with flat side out as shown. No
washer is needed for H-channel installation.
Use washer for panel installation only as
shown in photo.
GLAZING PANEL
8MM POLYCARBONATE
PANEL SPLICE "H" CHANNEL
TEK SCREW
END WALL FRAME TUBE
END WALL FRAME TUBE
TEK SCREW & NEO-BONDED WASHER
Diagram shows basic panel installation and fasteners used
to secure polycarbonate panels.
Use an FA4484B Tek screw and washer
to secure panel to end wall frame. Do not
crush panel when installing screws.
Install End Wall Cladding
A
