4
106205_06_07_08
Revision date: 08.30.18
Important Information
REQUIRED TOOLS
The following list identifies the main tools needed for assembly. Additional
tools and supports may be needed depending on structure and location.
• Tape measure or measuring device.
• Marker to mark locations on pipes.
• Clutched drill driver to drive Tek screws. (Cordless with extra batteries
works best.)
Do not use an impact driver to install Tek screws.
• Saw for metal and wood cutting.
• Wrench and socket set, or an adjustable wrench.
• Scissors, utility knife, and tin snips.
• Flat bar or putty knife
• Drill and drill bits
• Chalk line
• Caulk gun to apply sealant
• Hammers and gloves.
• Adjustable pliers and self-locking pliers.
• Ladders, work platforms, and other machinery for lifting designed to work
safely at building height.
UNPACK AND IDENTIFY PARTS
The following steps will ensure that you have all the necessary parts
before
you begin.
1. Unpack contents of shipment and place where you can easily inventory
parts. Refer to Bill of Materials/Spec Sheets.
2. Verify all parts listed on Bill of Materials/Spec Sheets are present. If
anything is missing or you have questions, consult the Pictorial Parts
Guide and all diagrams for clarification, or contact Customer Service.
NOTE:
At this time, do not open plastic bags containing smaller parts
such as fasteners or washers (if equipped).
SPECIAL NOTE: BASEBOARDS FOR FRAME (Customer-Supplied)
If desired, baseboards can be installed at ground level along each side of
the frame. Baseboards run front to back of assembled frame. Recommended
dimensions: 2" x 6"; Length as needed.
This baseboard is
not included
and must be supplied by the customer if
used. Treated or recycled plastic lumber works best for a baseboard when
allowed. The baseboard, when installed properly, helps prevent ground posts
from sinking when anchored and helps seal the greenhouse along sides at
ground level.
Building includes 1/4" hardware to attach customer-supplied baseboards:
1/4" x 4" (FAH009B) carriage bolts and 1/4" (FALB01B) nuts.
IMPORTANT:
If used, install baseboards
after
all polycarbonate panels are
installed.
See Guide #2.
ASSEMBLY NOTE:
Install Tek screws using a clutched drill driver
running approximately 750 RPM while applying approximately 50 lbs
of force.
Do not use an impact driver to install Tek screws!
POLYCARBONATE PANELS
Do not allow panels to remain in direct sunlight with protective film
in place. Doing so will cause protective film to become difficult if not
impossible to remove before installation.
Store panels indoors or cover with a light-colored tarp until you are
ready to install.
QUICK START GUIDE
For a quick overview of the building and its components, consult the
information and diagrams in the Quick Start section near the back of these
instructions.
