7
Revision date: 02.17.17
3
Assembly Instructions
ATTACH PIVOT ARM ASSEMBLY TO BASE AND ANCHOR BASE TO PIER
Complete these steps:
1. Connect each pivot arm assembly to a mounted base plate using the fasteners noted below. Apply a thin film of grease to each bolt before installing.
Part Number
Description
Quantity
104804
5/8" x 5" A325 HEAVY HEX BOLT GLV
2
108851
WASHER 5/8" F436 GALV A325
4
104806
5/8"-11 DH GRADE HD HEX NUT GALV A325
2
ATTENTION:
Tighten the bolt and nut until snug. Pivot arm should swing freely
when bolt is tight.
After tightening fastener, grease the bushing to ensure the connection is
properly lubricated. Use a multi-purpose grease.
Apply thin film
of grease.
2. Verify that concrete has set and mark the anchor bolt locations on the pier. Use the pivot arm assembly to position the base correctly. See diagram below.
3. After marking the anchor bolt locations, drill the bolt holes in the pier
using a 3/4" masonry bit.
Install pivot arm
assemblies parallel
with the rafter at each
end of the frame.
Dimensions from the
building rafter to the
pivot arm assembly
will be the same
throughout the length
of the pivot arm when
installed correctly.
End
Rafter
NOTE:
Do not drill concrete if it has
not set. Doing so may cause it to crack
when anchor bolts are driven into place.
4. Set base in place and drive anchor bolts
into mounting holes.
5. Tighten the nuts to secure the assembly
to the pier.
6. Repeat the steps to attach the remaining
base plate to the remaining pier.
7. Continue with the next procedure.
FAW605
Anchor Bolt
