22
H5_30_Wide_HT_Roll_Up
Revision date: 06.28.19
Install Ribbon Board — Required
RIBBON BOARD INSTALLATION
Gather parts:
• Ribbon Board Material: 2" x 6" treated lumber (supplied by customer) to attach to rafters.
• 1/4" x 4" carriage bolts (FAH009B), FAME50B (1/4") flat washers, and FALB01B (1/4") nuts (included).
Size and type of material may require alternative steps. When properly installed, ribbon board runs length of frame
along each side.
Ribbon board is supplied by customer.
Complete these steps:
1. Mark ribbon board height along outside of frame from end-to-end using a chalk line.
Consult diagrams on next
page for position and dimensions.
2. Align board with outer edge of end rafter and attach to frame. Use hardware noted above and on next page.
3. Continue adding boards to complete first run. Secure splices
between rafters
as shown in baseboard procedure.
Use a short section of material to secure splice between separate boards using customer-supplied fasteners.
4. Repeat steps to install second run of ribbon board along the other side.
5. After ribbon board is fully installed, continue with installation of side 102197 u-channel.
Ribbon Board
Actual frame may differ
from example shown.