37
Revision date: 06.28.19
H5_30_Wide_HT_Roll_Up
Install Anti-Billow Ropes
2 Runs of U-Channel with
Ribbon Board
INSTALL ANTI-BILLOW ROPES
Anti-billow ropes secure panels when they are fully or partially open. Using the
diagrams below, complete the anti-billow rope installation.
Complete these steps:
1. Beginning at
one end rafter
, take two (2) eye screws
(FA1960) and attach one near the bottom edge of
the baseboard and one to ribbon board (between
u-channel runs). Align eye screws with each other.
2. Using the sample diagrams as guides, move to next
rafter and attach eye screw to either the baseboard
or ribbon board, depending on pattern.
3. Continue installing eye screws until you reach the
other end rafter and finish installation by repeating
Step 1. Install eye screws for remaining side.
4. Install anti-billow rope
in short lengths along each
side
. Thread free end of rope through end rafter
eye screws and through eye screws at two to three
interior rafters. Cut rope and tie ends to eye screws.
5. Repeat this pattern of
installing short rope lengths
for remainder of the first side and the other side.
6. Repeat all the steps to install the remaining roll-up
side components for the other side if needed.
7. Continue by reading the wind panel information on
the next page. Complete that procedure if you want to
install wind panels.
NOTE:
The use of wind panels is optional. Materials
included for wind panels can be used for other
projects if wind panels are not used.
Anti-Billow Rope
B
Baseboard
FA1960
Eye
Screw
A
FA1960
Eye
Screw
Ribbon Board: Roof
Covered with film or
5.2 oz cover
Ground Level
ROPE
#1
ROPE
#2
ROPE
#3
End Point
End Point
A
B
ATTENTION:
INSTALL ANTI-BILLOW
ROPE IN
SHORT SECTIONS ALONG
EACH SIDE
TO KEEP PANEL
SECURE IN CASE ROPE BREAKS.