GROWSPAN
™
ROUND PRO GREENHOUSES AND SYSTEMS
14
Revision date: 01.23.19
STRUT INSTALLATION — FRAME SIDES AT EACH END
There are four (4) side struts for the frame. Struts are positioned between end rafters and first interior rafter. Gather parts:
• Struts (See Quick Start section for part identification.)
• Band Clamps (QH1402) — 2 per strut. (Installed earlier during frame assembly steps.)
Complete these steps to install struts:
1. Review diagrams in Quick Start section for additional details.
2. Attach strut upper end to end rafter band clamp. (Install clamp if needed.) Adjust strut position so lower end of strut
reaches band clamp on second rafter. (Install that band clamp too if needed.)
Strut
End Rafter
Interior
Rafter
Inside of Frame
A
Step 4
Tek
Screw
A
3. Attach lower end to band clamp on interior rafter. Install band clamp if needed.
4. Once strut is fully attached, drive an FA4482B Tek screw through each band clamp into rafter pipe. Install in a location
that will not contact roof or end wall cladding or side panels when these are installed.
5. Complete the next procedure.
*Baseboard installed later.
