GROWSPAN
™
ROUND PRO GREENHOUSES AND SYSTEMS
22
Revision date: 01.23.19
Secure all polycarbonate panels as shown in the diagrams
and photos below, unless otherwise noted.
Evenly space
Tek screws every 16".
GLAZING PANEL
8MM POLYCARBONATE
PANEL SPLICE "H" CHANNEL
TEK SCREW
END WALL FRAME TUBE
END WALL FRAME TUBE
TEK SCREW & NEO-BONDED WASHER
Use a Tek screw and washer to secure panel to end wall
frame. Do not crush panel when installing screws.
Diagram shows basic panel installation and fasteners used
to secure polycarbonate panels.
Install H-channel with
flat side out.
Complete these general steps to install end panels.
1. Consult panel location diagrams and begin at the edge
of double door opening. Work to the outside edge of
end wall. See
A
in diagram below for first panel.
Mark UV Side
X
3. Apply vent tape to bottom of panel.
NOTE:
Review Polycarbonate Panel diagram in Quick
Start section near the back of this guide to select the
correct panel for installation.
2. Cut panel to size, remove protective film, and mark
UV-protected surface. Install this surface toward the
outside.
A
