GRS Silentair 50-15 Instructions Download

Page: 3 / 4

This Compressor Fan should be used to correctly

prevent overheating that may affect normal

operation.

INSTALLATION

1. Mount the fan on the handle post of your

compressor. (Fig. B–2, Fig. C–3).

2. Use the U-bolts to secure the fan to the

handle post.

NOTE: The white nylon washers are used as

spacers as needed for smaller diameter posts to

tighten the fan in place.

3. Plug the cord into an A.C. outlet and test air flow

(Fig. B–1).

4. Make sure the air is directed into the compressor

head, not away from it.

5. Use the fan during extended periods of

compressor use.

• Turn off the fan when compressor is off.

Auxiliary Cooling Fan comes with a 1-Year

Limited Warranty.

Auxiliary Cooling Fan

PART #004-693 / #004-693-230

INSTRUCTIONS

Fig. B • SIDE VIEW

Fig. C • TOP VIEW

VERY IMPORTANT: The fan must be

positioned so the direction of the air flow is

directly into the compressor head (Fig. C–4).

LIT-086 / LIT-073

Summary of Contents for Silentair 50-15

Page 1: ...For most secure fit place back of bracket against a flat side of the Standing T Fitting 3 Install the Silentair Regulator Air Filter Fig A 1 by threading it onto the pipe nut located on the T Fitting...

Page 2: ...or has been adjusted to provide a maximum of 80 psi plus or minus 10 psi By operating at this conservative 80 psi pressure the compressor stays cooler The air pressure is ample for operating air tools...

Page 3: ...in place 3 Plug the cord into an A C outlet and test air flow Fig B 1 4 Make sure the air is directed into the compressor head not away from it 5 Use the fan during extended periods of compressor use...

Page 4: ...Compressor Oil 10 050 004 Tubing 15 ft 11 050 004 Tubing 50 ft 12 050 008 Tubing CONNECTION FOR GRAVERMAX GRAVERMATE or SYSTEM 3 CONNECTION FOR GRAVERMACH AT GRAVERMACH GRAVERMAX G8 GRAVERMAX SC or GR...