GENO
®
-flushing compressor 1988 K
Order no. 015 151 963-inter Created: KONS-gmei-mrie G:\BA-151963-INTER_GENO-SPUELKOMP-1988_K.DOC
52
G Troubleshooting
1 | Introduction
Operational errors cannot be completely ruled out even when the
flushing compressors have been designed and produced with care and
operated as intended. Table G-1 provides an overview of the possible
errors when operating the flushing compressor, their causes and
remedying.
Note:
The general and safety instructions in chapter A as well as the
designated application, application limits and technical specifications in
chapter C must be observed.
Danger!
Before performing any maintenance or care work on the
flushing compressor, this must be disconnected from the mains,
depressurised and effectively shut off and protected from pressure
sources. Pull out the power plug and empty the drain valve.
Note:
The compressor aggregate features a self-venting start unloader
valve. With proper operation, a longer blast of air can be heard each
time the system is started and a short blast of air is heard when the
system is switched off.
Note:
Grünbeck's technical customer service/authorised service
company must definitely be notified in case of errors that cannot be
eliminated with the information given in table G-1! When reporting
errors please also state the designation, order no. and serial no.
of the flushing compressor.
