GENO
®
-flushing compressor 1988 K
Order no. 015 151 963-inter Created: KONS-gmei-mrie G:\BA-151963-INTER_GENO-SPUELKOMP-1988_K.DOC
55
2 | Care work
This work must be performed regularly by a specialist regardless of how
often the system is used.
Perform before use:
Flush out the water path with drinking water directly into the drain.
If necessary, disinfect the water path, depending on the period of time
since the system was last used and application type (drinking water or
heating system).
Perform after use:
Drain off the condensation via the compressed air vessel's
condensation drainage valve.
Set up the flushing compressor so that the condensation drainage
valve on the compressed air vessel points downwards and keep this
open until only air comes out.
Drain off the condensation via the flushing compressor's flushing air
pressure regulator. For this, push the draining nozzle upwards.
Remove any remaining water from the water path.
3 | Inspection
The regular inspections can be performed by the operator or by a
trained expert contracted by him.
Visual inspections to ensure the perfect condition of safety devices
(e.g., housing parts, motor protective grid, ...), electric cables, tubes
and actuate the safety valve (pull the ring downwards, air flows out.
This is leakproof again when the ring is released).
In the case of any damage to electrical or pressurised components,
disconnect these from the mains or depressurise them and have them
checked/repaired by a specialist.
