En
gl
is
h (
G
B)
16
5. Handling and storing the product
5.1 Handling the product
Before handling the product, see section
5.2 Storing the product
During long periods of storage, protect the pump
against moisture and heat.
After a long period of storage, inspect the pump
before putting it into operation. Make sure that the
impeller can rotate freely. Pay special attention to the
condition of the shaft seal and the cable entry.
6. Product introduction
6.1 Product description
Fig. 9
SL1.50.65 and SLV.65.65 pumps
Fig. 10
SLV.65.65 pump
6.2 Applications
The compact design makes the pumps suitable for
both temporary and permanent installation.
The pumps can be installed on an auto-coupling
system or stand freely on the bottom of a pit.
SL1 and SLV pumps are portable and designed for
pumping domestic and industrial sewage and
wastewater.
6.3 Pumped liquids
SL1.50.65
The product is designed for pumping these liquids:
•
large quantities of drainage and surface water
•
domestic wastewater with discharge from toilets
•
wastewater from commercial buildings without
discharge from toilets
•
sludge-containing industrial wastewater
•
industrial process water.
SLV.65.65
The product is designed for pumping these liquids:
•
surface water with abrasive particles
•
municipal sewage
•
sewage from commercial buildings
•
sludge- or fibre-containing industrial wastewater.
TM
06
59
18
03
16
T
M
06
59
37
03
16
3
9
1
2
5
6
7
8
4
3
9
1
2
5
6
7
8
4
Pos. Description
1
Cable plug
2
Nameplate
3
Outlet port
4
Outlet flange DN 65, PN 10
5
Lifting bracket
6
Stator housing
7
Oil screw
8
Clamp
9
Pump housing
