2.1.6 Do not install near the vents or flues.
2.1.7 Do not install in areas where the temperature can easily
decrease to -10°C or exceed 40°C, unless you especially need
to install like this.
2.1.8 Do not install in areas where there are a lot of lampblack and
dust which will block up the sensor.
2.1.9 Do not install in too damp areas.
2.1.10 Do not install near kitchen wares or cooking equipment.
2.2 Installation instructions
Install the unit where it’s easy for the user to test and operate. For wall
mounting, the height of installation position should be more than 1.5m.
The unit should be at least 0.3m from the ceiling. Besides, the unit
should keep 1.5m away from the corner, wall side and large furniture.
Steps of alarm installation
a. Take out the mounting plate and line it with the wall in the position
that you have chosen for installation. Mark the holes with a pencil
dot. With the aid of your wall punch and hammer,make two holes
(6mm diameter, 40mm depth) on the marked spots.
b. Insert the two plastic anchors into the holes. Secure the mounting
plate to the wall upwards by screwing.
c. After making sure the mounting plate is secured to the wall, power
on the detector and test according to 1.4.4. If the test result is
normal, then slide the alarm down over the mounting plate until it
snaps into place.
2.3 Notes for installation
• The detector cannot snap into place until the batteries are installed
correctly. Please don’t force to install in avoidance
of damage.
• If you install the alarm in the garage, please do not install the
alarm near the exhaust port of motor vehicles. Because when your
car starts, high concentration of CO will be discharged and the
temporary CO that will not kill lives may cause the alarm.
WARNING
:
In order to ensure the product is correctly installed and used, it
