16
Setting the time
When connecting up the hi-fi system to the main power supply for
the first time, switch to standby mode. The clock flashes in the dis-
play to indicate that it needs to be set. When this setting is being
made, if no button is pushed for more than 10 seconds, the hi-fi sys-
tem will end the process automatically. You then have to start again.
1
Hold down »
CLOCK
« on the hi-fi until »
24 HOUR
« appears in
the display.
2
Press »
5a
« or »
s6
« to select between 12 and 24 hour clock
format and press »
CLOCK
« to confirm.
– Display: the hours flash.
3
Set the hours with »
5a
« or »
s6
« and confirm with
»
CLOCK
«.
– Display: the minutes flash.
4
Set the minutes with »
5a
« or »
s6
« and confirm with
»
CLOCK
«.
– Display: for example, »
CT OFF
«.
5
To activate the RDS time synchronisation, select »
5a
« or
»
s6
« »
CT ON
« and press »
CLOCK
« to confirm.
Note:
Some RDS stations transmit an RDS time signal. If the selected
RDS station transmits this time information, the clock is updated
automatically if the RDS time synchronisation (»
CT ON
«) is acti-
vated. This takes about five minutes.
Tuning and storing radio stations
Automatic station search
1
Switch the hi-fi system on from standby mode by pressing
»
TUNER
«.
2
Press »
TUNER
« to select the frequency band (FM or MW).
– Display: »
FM
« or »
MW
«.
3
Activate the station search by pressing and holding down
»
5a
« or »
s6
« until the frequency display changes to rapid
run-through.
– The search stops when a channel is found.
SETTINGS
______________________________________________
24 HOUR
00
:00
CT OFF
FM 87.50MHz