16
SETTINGS
____________________________________________________________________________
Setting the clock
The following settings can only be carried out in stand-by mode.
1
To set the 12-hour format, briefly press »
TIME
«.
– Display: »
12HR
« briefly, then the current time e.g. »PM
1:25
« (»AM« for
the morning, »PM« for the afternoon/evening).
2
To set the 24-hour format, press »
TIME
« again.
– Display: »
24HR
« briefly, then the current time e.g. »
13:25
«.
3
To set the time, press and hold down »
TIME
«.
– Display: The hours flash.
4
Set the hours using »
TUNING UP/DOWN
« on the device.
5
Confirm the input with »
TIME
«.
– Display: The minutes flash.
6
Set minutes with »
TUNING UP/DOWN
« on the device.
Note:
You must reset the time after a power failure or when the mains plug is pul-
led out.
7
Confirm the input with »
TIME
«.
– Display: e.g. »
CT ON
«.
– The RDS time synchronization is activated.
Note:
If the RDS time information is received via an RDS station, the time sets itself
automatically.
When receiving and RDS station, the time is continuously updated later pro-
vided that an appropriate time signal is transmitted and the function is swit-
ched on.
C T
O N
1 0
1 4
:
1 2
1 4
:
PM
1
2 5
:
