44
INFORMATION
__________________________________________________________________________
Rectifying minor problems
Not every kind of sound interference is caused by a defect in your HiFi system. Impairment
can also be caused by leads having been accidentally pulled out, damaged CDs and worn
out batteries in the remote control. If the following measures do not bring about satisfactory
results, consult an authorised dealer.
Fault
No sound.
The system does not respond when
buttons are pressed.
The remote control does not work.
Poor radio reception.
Tracks on a CD are skipped.
CD-Rs are not being played back, or
being played back incorrectly.
Possible cause/remedy
The volume setting is too low – increase the volume.
The headphones are plugged in – disconnect the head-
phones.
The power cord is incorrectly connected. Connect it
properly.
Mute is activated
Static electrical discharge. Switch off the device, disconnect
the power cable and plug it in again after a few
seconds. Press the »
RESET
« button.
The batteries are flat – replace the batteries.
The remote control is out of range of the stereo.
Weak antenna signal – check the antenna.
Interference from electrical devices such as televisions,
video recorders, computers, neon lamps, thermostats or
motors. Keep the stereo away from such devices.
The CD is damaged or dirty – replace the CD or clean it.
The PROGRAM (track memory) or RANDOM functions
are active. Deactivate the functions.
Faulty software or hardware settings for burning, or the
CD being used is faulty.
Check the components of your CD burner/burner
software or change the CD you are using.
Technical and optical modifications reserved
