73
ENGLISH
SERVICE MENU SETTINGS
-------------------------------------------------------------------
To enter service menu, just like in the previously
launched products, we press menu button of the
remote control and enter 9, 3, 0, 1 or 8, 5, 0, 0.
As the chassis improvement and development
works go on throughout the production, service
menu items may vary according to the software
version. The following explanations are service
menu settings of the current version.
System Configuration
This menu contains general settings of the sys-
tem. Press OK button on the remote control to
access this menu.
7
TV MODE tab contains "Factory" and "Cus-
tomer" options. It is used to perform factory
controls and settings more efficiently and faster.
On the TVs delivered to the customer, this setting
is absolutely selected as "Customer". Otherwise,
it will lead to customer complaints such as "TV
automatically turns on after power failures" or
"different functions operate from the remote
control".
7
PLUG PLAY (Demo Mode): A navigation key is
pressed after having completed all settings and
checks in the factory. Later, "Please wait" mes-
sage appears; and when you see the message
"DONE", the device should be unplugged and
plugged again. With this process, television will
be set to its initial values before delivery. It will
be proper to set Plug&Play tab after service.
After pressing right key on the tab, the flash will
be installed with factory defaults. TV can be
shipped to the customer after this setting. Please
note that any warning is not displayed or you
do not have to exit the menu while Plug&Play is
getting activated. You should be careful not to
take the device into Plug&Play mode by mistake.
7
PANEL ENERGY CLASS header is used for
selecting the energy class of the product. Prod-
uct is set to specifications in the factory. Panel
brightness levels available in the NAND Flash
are used according to the product energy class.
7
HOTEL tab should be set to "On" with the
products for which the Basic Hotel TV feature
is desired; and it should be set to "Off" in other
products. When the hotel model is "On", certain
features designed for the hotel use are activat-
ed; the user cannot change the channels set by
the service, for example, or the volume cannot
be increased more than a certain level.
Source Configuration
This menu can be accessed by pressing 2,3,5,6
on the remote control. The settings under source
configuration tab determine which sources will
be on and which ones will be off depending
on customer demands. PC source cannot be
selected in GM-chassis products as they do not
have VGA connector.
TV Configuration
This menu contains configuration settings of
TV. We may select amongst the menus that are
being used and to be used on TV. These set-
tings differ from the "System Configuration". This
menu contains the changes which the user can
directly observe.
To enter this menu, you should go to "TV con-
figuration" from the service menu and enter the
numbers 2, 3, 5, 6 in sequence.
Summary of Contents for COREMAX M1 PROJECT GM
