Drive Mechanism
GV 29…, GV 9000…, GV 9300…
k
5 - 28
GRUNDIG Service
70400 Cassette lid opener
Apply grease
(part no. 75988 061 7800)
Fig. 8.34
Apply grease (part no. 75988 061 7800)
to the bottom of the clamp
Fig. 8.35
8.12 R/P Head Assy (Pos. 50200)
– Undo the screw (Pos. 50210), press the R/P head assy
(Pos. 50200) in the direction of the arrow as shown in Fig. 8.36 and
remove it upwards.
Note:
Align the hole
U
of the R/P head assy (Pos. 50200) and pin
V
on the mechanism chassis.
Subsequently, adjust the tape path and tracking position
(X value, refer to point 9. „Adjustments“).
50210
Screw
50200 R/P Head assy
Hole
Pin
U
V
Fig. 8.36
8.13 Tape Drum
– Undo two screws (Pos. 30000), remove the motor stator
(Pos. 22000) and the tape drum earth spring (Pos. 11600,
Fig. 8.37).
– When turning the mechanism upside down now, the carbon chip
(Pos. 11500) will fall out (Fig. 8.37).
– Undo two screws (Pos. 30000) and remove the motor rotor
(Pos. 21000, Fig. 8.37).
– Undo the three screws (Pos. 10400) at the bottom of the mechanism
and take the complete tape drum (Pos. 11000) out (Fig. 8.39).
11000
Tape drum
22000 Motor stator
Flexible cable
30000 Screws
11600
Earth spring,
tape drum
11500 Carbon
chip, tape drum
30000
Screws
21000
Motor rotor
Fig. 8.37
