5.3.13. SEQUENCE
The function executes the pre-positioning of the pan, tilt, zoom and focus features in a certain sequence for a
camera. Before setting this function, users must preset at least two preset points.
SEQUENCE LINE:
There are eight sets of sequence lines built in the Dome Camera. Please use the LEFT/RIGHT direction keys to
first select a line and then set its sequence points.
SEQUENCE POINT:
Up to 64 points can be specified for each sequence line. A Sequence Point represents the location of a preset in
an order of preset points that the Dome Camera will automatically run. The following setup items, including
PRESET POSITION, SPEED and DWELL TIME, will influence how the camera runs through each sequence point.
PRESET POSITION:
Users can assign a specific preset position to the selected sequence point with this item.
SPEED:
Users can set the speed of the transition from one sequence point to the next one. The range of speed is from 1 to
15. Within this range, PAN and Tilt speed varies from 5 to 300 degrees/sec.
DWELL TIME:
The DWELL TIME is the duration during which the Dome Camera stays at a sequence point. The range of duration
time is from <000> to <127> seconds. The Dome Camera will go to the next sequence point when the DWELL TIME
expires. If the setting is <000>, the Dome Camera will stay at this sequence point until the user manually moves
the camera.
RUN SEQUENCE:
With this item, users can command the Dome Camera manually to run the selected sequence line.
EXIT:
Select this item to exit the SEQUENCE menu and go back to MAIN PAGE 2 to set up an Auto Pan.
NOTE: Users can execute the sequence function through a keyboard. Please refer to the control keyboard’s quick
guide for further information.
23
English
Summary of Contents for GCA-C0335P
