EN / 29
Spin Speed Adjustment button only
works backwards. For example, if
you want to select 1000 rpm while
800 rpm (cycle/min) is written on
the display, you need to press the
button several times until you reach
1000 rpm, going backwards from
800 rpm.
If you are not going to unload your laundry
immediately after the programme com-
pletes, you can use Rinse Hold function in
order to prevent them from getting wrinkled
when there is no water in the machine.
This function holds the laundry in the
final rinsing water. If you want to spin
your laundry after the Rinse Hold
function:
a. Adjust the Spin Speed.
b. Press Start / Pause. The programme will
resume. Machine drains the water and
spins the laundry.
If you want to drain the water at the end of
the programme without spinning, use No
Spin function.
No change can be made in pro-
grammes where spin speed adjust-
ment is not allowed.
You can change the spin speed after the
washing starts if the washing steps allow it.
Changes cannot be made if the steps do
not allow it.
Auxiliary function selection for drying:
When you select a new washing program,
press the Auxiliary Function Selection but-
ton to set the drying option suitable for this
program.
In programmes that do not allow
the drying setting, when the Drying
auxiliary function button is pressed,
the drying light will not change and
a warning noise will be heard.
For only drying programmes, set
the appropriate drying option by
pressing the Auxiliary Function Se-
lection button.
6.8 Drying Programmes
WARNING
The machine automatically cleans
the lint that from the laundry during
drying programme. The machine
uses water during drying. For this
reason, the water tap of the ma-
chine should also be open during
drying programmes.
When you select a new washing
program, press the Auxiliary Func-
tion Selection button to set the dry-
ing option suitable for this program.
In drying programmes, there is a spinning
step. Your machine performs this process
in order to shorten the drying duration.
When the drying programme is selected,
the spin speed setting is in the range of
Maximum spin speed.
In programmes that do not allow the drying
setting, when the Drying auxiliary function
button is pressed, the drying light will not
change and a warning noise will be heard.
For only drying programmes, set the appro-
priate drying option by pressing the Auxili-
ary Function Selection button.
In case of water outage, washing
and drying cannot be performed.
• Synthetic Dry
Use this programme to dry synthetic laun-
dry with a dry weight of up to 4 kilograms.
You can only dry in this program.
For the dry weight of the laundry,
see Correct Load Capacity
