EN / 40
plete, you can use all products with the
HomeWhiz feature in your house on this
account.
You can touch the “Appliances” tab in the
HomeWhiz application to view appliances
paired with your account. Following the in-
stallation of the application, HomeWhiz
function enables the washing machine to
send you instant notifications via your
smart appliance.
In order to use the HomeWhiz func-
tion, the application must be in-
stalled on your smart appliance,
and your washing machine must be
paired with your smart appliance
via Bluetooth. If your washing ma-
chine is not paired with your smart
appliance, it will work like an appli-
ance without HomeWhiz feature.
Your product will work when it is
paired with your smart appliance
via Bluetooth. Controls that have
been made through the application
will be activated with this pairing.
Therefore, the strength of the
Bluetooth signal between the
product and the smart appliance
should be sufficient.
Please visit
learn which Android and IOS ver-
sions are supported by HomeWhiz
application.
All safety measures described in
the
"GENERAL SAFETY IN-
STRUCTIONS”
titled section of the
user manual are also valid for re-
mote operation with HomeWhiz
function
6.20.1 HomeWhiz Setup
In order for the application to run, a con-
nection between your appliance and the
HomeWhiz Application must be estab-
lished. For this connection to be estab-
lished you must follow the steps below for
setup procedure on both the appliance and
the HomeWhiz Application.
a. If you are adding a device for the first
time, touch “Appliances” tab on the
HomeWhiz Application. Select “ADD
APPLIANCE” (touch here for setting up
a new appliance) button in the upper
right corner. Perform the setup by fol-
lowing both the steps below and the
steps in the HomeWhiz Application.
b. To start the setup, make sure that your
machine is turned off. Press and hold
the Temperature button and the Remote
Control Function button simultaneously
for 3 seconds to switch your machine to
HomeWhiz setup mode.
c. When the appliance is in HomeWhiz
setup mode, you will see an animation
on the display and the bluetooth icon
will flash until your machine gets paired
with smart device. Only programme
knob will be active in this mode. Other
buttons will be inactive.
d. Follow the instructions in display of
HomeWhiz application.
e. Wait until the installation is complete.
When setup is complete, give your
washing machine a name. Now, you
can tap and see the product you have
added in the HomeWhiz Aplication.