Grundig GFN3671G, User Manual

11

3.2 Reversing The Doors

We recommend that you reverse 

the door before switching on for the 

first time.

Tools required: Small and medium 

size flat and cross-headed 

screwdrivers, a pair of pliers. 

Spare Parts supplied in the plastic 

bag: The following parts, which are 

exclusively for left hand side fitted 

hinge operation are supplied in a 

plastic bag with the appliance:

- Door top trim hinge covers – there 

are 2 different parts, one for each 

side of top trim. 

We suggest you keep all the parts 

supplied in the plastic bag and also 

parts, which have been removed 

when reversing the door, in a safe 

place for possible future, re-use.
Important: 

We suggest you ask somebody 

to help you when moving the 

appliance around and to hold the 

door when removing / re-fitting 

hinges and the door to avoid any 

injury and damage to the product.

Please refer to diagrams supplied. 

To follow numbers in brackets 

below, refer to the main diagram.

1. 

Switch  off the appliance at 

the socket outlet and pull 

out the mains plug.

2. 

Remove all loose items and 

fittings and food inside the 

appliance.

3. 

Gently prise off plastic hin-

ge covers on both sides 

of front top panel using a 

small flat-headed screwdri-

ver. (1-2)

4. 

Unscrew the bolts of the top 

hinge and remove top hin-

ge. (3)

5. 

Remove door carefully off the 

bottom hinge and stand door up-

right in a safe place.(4)

6. 

Gently prise off plastic hinge co-

ver on door top trim. Fit the ot-

her door top trim plastic off hin-

ge cover supplied in the plastic 

bag.(5)

7. 

Gently tilt the appliance back 

against a strong wall on its rear 

side sufficiently to allow the lo-

wer hinge to be removed. Take 

care to protect the appliance, 

your wall and floor coverings. 

You can utilise the original pac-

kaging to do this.  

Once you tilt the appliance back, 

check to make sure the applian-

ce is completely stable and safe 

before you carry  

on. (6)

8. 

Unscrew and remove the front 

feet and 1 bolt. (7)

9. 

Unscrew and remove the bottom 

hinge. (8)

10. 

Unscrew and remove the bottom 

hinge door stopper and bushing 

and reposition them on the other 

side while rotating  

the bus-

hing 180°. (9)

11. 

Fit the bottom hinge and tigh-

ten the screws as shown in figu-

re. (10)

12. 

Fit the other front feet as shown 

in figure. (11)

13. 

Rotate the top hinge 180°. 

Unscrew the hinge pin and re-

tighten it to the opposite side. 

(12) 

14. 

Fit the top hinge on the left hand 

side bushing of the door. (13) 

15. 

Locate and re-fit door to bottom 

hinge pin. (14)

16. 

Re-fit  the upper hinge on the 

opposite side by using a flat hea-

ded screwdriver. (15)