Grundig GKFED455, Installation & User'S Instructions

5

ELECTRICAL REQUIREMENTS

Before you insert the plug into the wall socket make sure that the voltage and the 

frequency shown in the rating plate inside the appliance corresponds to your 

electricity supply.

Rating label is on the left hand side of fridge inner liner.

We recommend that this appliance is connected to the mains supply via a

suitable switched and fused socket in a readily accessible position.

WARNING: When positioning the appliance ensure the supply cord is not trapped or 

damaged.

Should the mains lead of the appliance become damaged or should it need replacing 

at any time, it must be replaced by a special purpose made mains lead which can 

only be obtained from a 

GRUNDIG

 Authorised Service Agent

.

WARNING! THIS APPLIANCE MUST BE EARTHED

If the 

f

i

tted moulded plug is not suitable for your socket, then the plug should be cut 

off and an appropriate plug 

f

i

tted. Destroy the old plug which is cut off as a plug with 

bared cord could cause a shock hazard if inserted into a socket

elsewhere in the 

house.

The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need 

to be replaced an ASTABEAB approved BS 1362 fuse of the same rating must be 

used. Do not forget to re

f

i

t the fuse cover. In the event of losing the fuse cover the 

plug must not be used until a replacement fuse cover has been 

f

i

tted. Colour of the 

replacement fuse cover must be the same colour as that visible on the pin face of the 

plug. Fuse covers can be obtained from a

n

 authorised service agent.

IMPORTANT! FITTING A DIFFERENT PLUG

As the colours of the wires in the

mains lead of this

appliance may not correspond with the coloured

markings identifying the terminals in your plug 

proceed as follows: (See diagram).

1.

Connect the green-yellow or green (Earth) wire

to the terminal in the plug marked 'E' or with the

symbol       or coloured green and yellow or green.

2.

Connect the blue (Neutral) wire to the te

r

minal

in the plug marked 'N' or coloured black.

3.

Connect the brown (Live) wire to the terminal in

the plug marked 'L' or coloured red.
With alternative plugs a 13

A fuse must be

f

i

tted either in the plug or adaptor or in the main fuse box.

If in doubt contact a quali

f

i

ed electrician.

WARNING

: Do not locate extension sockets or charging transformers/power supplies 

or Lithium-Iron battery operated products adjacent to the compressor as they could 

overheat.