Refrigerator
/User Manual
11 / 20 EN
Refrigerator
/User Manual
Refrigerator
/User Manual
Preparation
C
The ambient temperature of the
room where you install the cooler/
freezer should at least be -15°C.
Operating your cooler/freezer under
colder conditions than this is not
recommended.
C
Inside of your cooler/freezer must be
cleaned thoroughly.
C
If two coolers are to be installed side
by side, there should be at least 4 cm
distance between them.
4.2 Initial use
Before starting to use the product, check that
all preparations are made in accordance
with the instructions in sections "Important
instructions for safety and environment" and
"Installation".
•
Clean the interior of the cooler/freezer as
recommended in the “Maintenance and
cleaning” section. Check that inside of it is
dry before operating it.
•
Plug the cooler/freezer into the grounded
wall outlet. When the door is opened the
interior illumination will turn on.
•
Run the cooler/freezer without putting any
food for 6 hours and do not open its door
unless certainly required.
C
You will hear a noise when the
compressor starts up. The liquids and
gases sealed within the refrigeration
system may also give rise to noise, even
if the compressor is not running and this
is quite normal.
C
Front edges of the cooler/freezer may
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.
C
Such loading will result in higher
energy consumption and worsen
freezer storage performance of your
appliance.
