13
TR
4. Preparation
4.1 Things to be done
for energy saving
A
Connecting the product
to electric energy saving
systems is risky as it may
cause damage on the
product.
•
Do not leave the doors of your
refrigerator open for a long
time.
•
Do not put hot food or drinks in
your refrigerator.
•
Do not overload the refrigerator.
Cooling capacity will fall when
the air circulation inside is
hindered.
•
Do not place the refrigerator
in places subject to direct
sunlight. Install the product
at least 30 cm away from heat
sources such as hobs, ovens,
heater cores and stoves and at
least 5 cm away from electrical
ovens.
•
Pay attention to store your
food in refrigerator in closed
containers.
•
You can load maximum
amount of food to the
freezer compartment of the
refrigerator by removing the
freezer compartment drawers.
Declared energy consumption
value of the refrigerator was
determined with the freezer
compartment drawers
removed,except if available
bottom drawer and with
maximum amount of food
loaded.
•
There is no risk in using a
shelf or drawer suitable for the
shapes and sizes of the foods to
be frozen.
•
Thawing frozen food in fridge
compartment will both provide
energy saving and preserve the
food quality.
•
The baskets/drawers that
are provided with the chill
compartment must always be in
use for low energy consumption
and for better storage
conditions.
•
Food contact with the
temperature sensor in the
freezer compartment may
increase energy consumption of
the appliance. Thus any contact
with the sensor(s) must be
avoided.
C
The ambient temperature
of the room where you
install the refrigerator
should at least be
-15°C. Operating your
refrigerator under colder
conditions than this is not
recommended.
Summary of Contents for GKNE 4750
