13
3.1 Appropriate location
for installation
In order to prepare the product for
use, refer the information in the user
manual and ensure that electrical
installation and water installation are
appropriate. If not, call a qualified
electrician and plumber to arrange
the utilities as necessary.
B
WARNING:
Manufacturer
shall not be held liable for
damages that may arise
from procedures carried
out by unauthorised
persons.
B
WARNING:
Product must
not be plugged in during
installation. Otherwise,
there is the risk of death
or serious injury!
A
WARNING:
: If the door
clearance of the room
where the product shall
be placed is so tight to
prevent passing of the
product, remove the door
of the room and pass the
product through the door
by turning it to its side;
if this does not work,
contact the authorised
service agent.
•
Place the product on a level floor
surface to prevent jolts.
•
Install the product at least 30
cm away from heat sources
such as hobs, heater cores and
stoves and at least 5 cm away
from electrical ovens.
•
Product must not be subjected
to direct sun light and kept in
humid places.
•
Appropriate air ventilation must
be provided around your product
in order to achieve an efficient
operation. If the product is to be
placed in a recess in the wall,
pay attention to leave at least 5
cm distance with the ceiling and
side walls.
•
Do not install the product in
places where the temperature
falls below -5°C.
3.2 Installing the
plastic wedges
Plastic wedges supplied with the
product are used to create the
distance for the air circulation
between the product and the rear
wall.
1.
To install the wedges, remove
the screws on the product
and use the screws supplied
together with the wedges.
Summary of Contents for GQN21220WX
Page 1: ...ENG www grundig co uk USER INSTRUCTIONS GQN21220WX...
Page 2: ......
Page 43: ...Notes...
Page 44: ...Notes...
