31
seconds off) until a total of 4 gal.
(15L) has been dispensed. This will
flush air from the filter and water
dispensing system, and prepare
the water filter for use. Additional
flushing may be required in some
households. As air is cleared from
the system, water may spurt out of
the dispenser.
Allow 24 hours for the refrigerator
to cool down and chill water.
Dispense enough water every week
to maintain a fresh supply.
C
After 5 minutes of
continuous dispensing,
the dispenser will stop
dispensing water to avoid
flooding. To continue
dispensing, press the
dispenser paddle again.
5.17 Dispensing water
Hold a container under the
dispenser spout while pressing the
dispenser pad.
Release the dispenser pad to stop
dispensing.
C
It is normal for the first
few glasses of water
taken from the dispenser
to be warm.
C
If the water dispenser is
not used for a long period
of time, dispose of first
few glasses of water to
obtain fresh water.
During initial use, you will have to
wait approximately 24 hours for the
water to cool down.
Take out the glass a little while
after you pull the trigger.
5.18 Maintaining water
dispenser
A
Before using your fridge
first time and after
replacing your water filter,
water dispenser may drip
drops of water. To prevent
water dripping or leaking
from dispenser, please
bleed the air from the
system by dispensing 5-6
gallons (about 20 liter) of
water through the water
dispenser before the first
use and every time after
you change the water filter.
This will remove any air
trapped in the system and
stop the water dispenser
from leaking. Checking
coupler position and the
straightness of water line
at the back of the unit will
be required if there’s an
obstruction in water flow.
Summary of Contents for GQN21220WX
Page 1: ...ENG www grundig co uk USER INSTRUCTIONS GQN21220WX...
Page 2: ......
Page 43: ...Notes...
Page 44: ...Notes...
