14
3.1 Appropriate installation
location
A
WARNING:
If the door
of the room where the
product will be placed
is too small for the
product to pass, then
the product's doors
can be removed and
the product turned
aside to pass it
through.
•
Choose a place at where
you would use the product
comfortably.
•
Install the product at least 30
cm away from heat sources
such as hobs, ovens, heater
cores and stoves. Product
must not be subjected to
direct sun light and kept
in humid places after
installation.
•
Appropriate air ventilation
must be provided around your
product in order to achieve
an efficient operation. If
the product is to be placed
in a recess in the wall, pay
attention to leave at least 5
cm distance with the ceiling
and side walls.
•
Do not place the product on
the materials such as rugs or
carpets.
•
Place the product on an even
floor surface to prevent jolts.
•
Do not install the product
in places where the
temperature falls below -5°C.
C
If two coolers are to be
installed side by side,
there should be at least
4 cm distance between
them.
3.2 Installing the
plastic wedges
Plastic wedges are used to
create the distance for the air
circulation between the product
and the rear wall. Insert the 2
plastic wedges onto the rear
ventilation cover as illustrated
in the figure. To install the
wedges, push and twist a
quarter of a turn.
Summary of Contents for GSBS16312B
Page 1: ...ENG www grundig co uk USER INSTRUCTIONS GSBS16312B...
Page 2: ......
Page 58: ...58 Notes...
Page 59: ...59 EN Notes...
