- 18 -
- 18 -
Setting output level of the channel strips
This setting is not urgently necessary with these Cassettes.
• Press the
button.
—> “
OUTPUT: LEVEL
CONTROL
” appears in the display.
Note:
In this mode a digital carrier is set to the analogue picture
carrier frequency of the output channel of the respective
channel strip. Thus you can measure the absolute output
level using an analogue test receiver.
• Measure the output level of the channel strip using the con-
nected antenna test receiver.
• Press the
AUDIO
button to activate the menu
“
OUTPUT: LEVEL HF OUT:
”.
• Set the output level of the channel strip incrementally from
“
0
” to “
– 7
” dB by pressing
.
• Press the
button twice.
—> The menu “Producing a QAM signal for testing” –
“
OUTPUT: RANDOM
” is activated.
Bx 1A
LEVEL HF OUT:
OUTPUT:
0
0
…
-7
Bx 1A
LEVEL
CONTROL
OUTPUT:
Bx 1A
LEVEL HF OUT:
OUTPUT:
0
0
…
-7
Bx 1A
LEVEL
CONTROL
OUTPUT:
