33
EN
IT
8. Troubleshooting
Drying process takes too much time.
• Pores of the lint filter are clogged. >>>
Wash the lint filter with warm
water.
• Filter drawer is clogged. >>>
Wash the sponge in the filter drawer.
• Ventilation grids on the front side of the machine are blocked. >>>
Remove the objects (if any) that block ventilation in front of the
ventilation grids.
• Ventilation is not sufficient since the room where the machine is
installed is very small. >>>
Open the door and window of the room to
avoid the room temperature increase too much.
• Lime deposit has built up on the dampness sensor. >>>
Clean the
dampness sensor.
• Excessive laundry is loaded. >>>
Do not load the dryer in excess.
• Laundry is not spun sufficiently. >>>
Spin your laundry at a higher
speed in your washing machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual
dampness level.
• It is likely that the selected programme did not suit the laundry
type.>>>
Checking the care labels on clothes, select appropriate
programme for the laundry type or use timer programmes in addition.
• Pores of the lint filter are clogged. >>>
Wash the lint filter with warm
water.
• Filter drawer is clogged. >>>
Wash the sponge in the filter drawer.
• Excessive laundry is loaded. >>>
Do not load the dryer in excess.
• Laundry is not spun sufficiently. >>>
Spin your laundry at a higher
speed in your washing machine.
Dryer does not switch on or the programme does not start. Dryer does not
start when it is set.
• It is not plugged in. >>>
Make sure that the machine is plugged in.
• The loading door is ajar. >>>
Make sure that the loading door is closed
securely.
• Programme is not selected or the Start / Pause / Cancel button is
not pressed. >>>
Make sure that the programme is selected and the
machine is not in Pause mode.
• Childproof Lock is activated. >>>
Deactivate the Childproof Lock.
Programme is interrupted without any cause.
• Loading door is ajar. >>>
Make sure that the loading door is closed
securely.
• There was a power failure. >>>
Press Start / Pause / Cancel button to
start the programme.
• Water tank is full. >>>
Drain the water tank.