80
8. Troubleshooting
Drying process takes too much time.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm
water.
• Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the
filter drawer.
• Ventilation grids on the front side of the machine are blocked. >>> Remove
the objects (if any) that block ventilation in front of the ventilation grids.
• Ventilation is not sufficient since the room where the machine is installed
is very small. >>> Open the door and window of the room to avoid the
room temperature increase too much.
• Lime deposit has built up on the dampness sensor. >>> Clean the
dampness sensor.
• Excessive laundry is loaded. >>> Do not load the dryer in excess.
• Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed
in your washing machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual
dampness level.
• It is likely that the selected programme did not suit the laundry
type.>>>Checking the care labels on clothes, select appropriate
programme for the laundry type or use timer programmes in addition.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm
water.
• Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the
filter drawer.
• Excessive laundry is loaded. >>> Do not load the dryer in excess.
• Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed
in your washing machine.
Dryer does not switch on or the programme does not start. Dryer does not
start when it is set.
• It is not plugged in. >>> Make sure that the machine is plugged in.
• The loading door is ajar. >>> Make sure that the loading door is closed
securely.
• Programme is not selected or the Start / Pause / Cancel button is not
pressed. >>> Make sure that the programme is selected and the machine
is not in Pause mode.
• Childproof Lock is activated. >>> Deactivate the Childproof Lock.
Programme is interrupted without any cause.
• Loading door is ajar. >>> Make sure that the loading door is closed
securely.
• There was a power failure. >>> Press Start / Pause / Cancel button to start
the programme.
• Water tank is full. >>> Drain the water tank.