18
Setting and storing radio stations
Automatic station search
After the hi-fi system has been connected to the mains for the first
time, the device in tuner mode searches for the 40 stations with the
best reception and stores them.
1
After connection, switch on the hi-fi system by pressing
»
ON OFF
«.
2
Press »
FUNCTION
« to select TUNER as the input source.
– Display: e.g. »
3
« for the station, the frequency in rapid run-
through and »
PROG
«.
– The search has started. After the search has finished, you will
hear the station stored at preset position 1.
Notes:
The automatic station search can be interrupted by briefly
pressing »
7
«.
The automatic station search can be repeated any time by
pressing and holding down »
P/RANDOM/
Ȅ
« until the fre-
quency display switches to rapid run-through. The stations
stored previously will be deleted.
Automatic station search
1
Switch on the hi-fi system by pressing »
ON OFF
« and select
the input source TUNER by pressing »
FUNCTION
«.
– Display: »
TUNER
«, then the wave band and frequency or
station name.
2
Press »
BAND
« to select the frequency band (FM or MW).
– Display: »
FM
« or »
AM
«.
3
Activate the station search by pressing »
A
TUNING
S
«
until the frequency display changes to rapid run-through.
– The search stops when a station is found.
Manual station search
1
To move the frequency forward in steps, briefly press
»
A
TUNING
S
« several times.
– The frequency changes in 50 kHz steps (FM) or in 9 kHz steps
(MW).
SETTINGS
_____________________________________________
3
89.55
PROG
TUNER
FM 87.65
ENERGY
PROG
MHz
!
f
MHz
CDS_7000_ DEC_en 21.05.2007 14:49 Uhr Seite 18
