ENGLISH
15
ACCESSORIES
___________________________________________________________________________
Video-controlled memory
If external picture/sound signals are to be permanently fed in (without
switching voltage), we recommend to feed in the picture/sound signals via
pin 10 of the Sub-D socket.
In this case, the picture/sound signals are fed in a clamped and controlled way
into the modulator. In this way, output levels of different strength from the external
equipment are adjusted accordingly.
For that, on the component side of the chassis board, you must
cut the two wire bridges BR 1068 (Audio, right) and BR 1093 (Audio, left),
for channel
LINE A
and
the two wire bridges BR 2068 (Audio, right) and BR 2093 (Audio, left),
for channel
LINE B
(see Figure on page 14).
In addition you must
resolder the two chip bridges
E
(for channel
LINE A
) and
F
(for channel
LINE B
) on the solder side of the cassette (see Figure below).
Chip brigde F (LINE B)
Chip brigde E (LINE A)
Continued on next page.
