Setting the clock
Your unit has a 24 hour clock.
• Select STANDBY mode with the
POWER
button.
• Press the
EDIT
button two times.
CLOCK
appears on the display
– The time starts flashing in the display.
• To set the time, press the
Q
SEARCH/TUNING
R
buttons. Each
short pressure of the buttons increases the displayed number by one.
Holding the button down increases the setting at high speed.
• Press the
MEMORY
button to store the setting.
• If you wish to leave the clock setting mode without changing the settings,
press the
EDIT
button again.
Note:
In case of a power breakdown, the actual clock time is stored in the
memory. When power returns the clock start running again from the stored time
onwards.
The timer function
Before setting the timer, ensure that the correct clock time is set.
Switching the timer on and off.
The timer can be switched on or off in any mode of the set, even in standby
mode.
• You can activate and deactivate the timer with a long pressure on the
INFO
button.
– If the timer is switched on, the display shows ‘
TIMER ON
’ during 1 second
and then returns to showing the original information. The LED in the POWER
button starts blinking.
– If the timer is switched off (another long pressure on the INFO button), the
display shows ‘
TIMER OFF
’ during 1 second and then returns to showing
the original information.
Setting the timer
• Select STANDBY mode with the
POWER
button.
• Press the
EDIT
button once. The display shows briefly
TIMER
.
– The start time starts flashing in the display.
e.g. ‘
02
:
30 ON
‘
• To set the start time, press the
Q
SEARCH/TUNING
R
buttons. Each
short pressure of the buttons increases the displayed number by one.
Holding the button down increases the setting at high speed.
• Press the
SKIP/STATION
P
button to prepare for setting the stop time.
• Adjust the stop time with the
Q
SEARCH/TUNING
R
buttons.
• Press the
MEMORY
button to store the timer setting.
– As soon as the timer is activated, the LED in the
POWER
button will start
flashing.
– The set will start with the same function that was active before the set was
switched to standby (same source, same tuner station or same track number
of the CD).
– If the set was already switched on when the timer is activated, the actual
function continues and the set switches off at the set stop time.
– After the timer procedure the set will be switched to standby and the LED in
the
POWER
button will stop flashing.
The SLEEP function (on the remote control)
Your unit is provided with a sleep function which switches the unit off after a set
time has elapsed.
This allows you, for example, to fall asleep to music. You don't need to switch
the unit to standby as this happens automatically when the time you set has
elapsed.
The
SLEEP
button is on the remote control.
• Press the
SLEEP
button once.
– '
SLEEP 60
' appears on the display.
– After one second the set will be switched on and after 60 minutes the unit
will automatically switch to standby.
• If you press the
SLEEP
button again within one second you can select the
other sleep times: 60 –> 40 –> 30 –> 20 –> 10 –> 5 –> 0.
– During the sleep function the SLEEP indication will be shown on the display.
Note:
• While the sleep function is still active, you can reset the sleep time to 60
minutes by pressing the
SLEEP
button.
• Deactivate the SLEEP setting by switching the unit to standby (with the
y
button on the remote control) or by pressing the
SLEEP
button until
'
SLEEP 0
' appears.
©
24
The Clock and Timer
GB
