ENGLISH
10
Connecting the iPod
The hi-fi system uses the iPod Universal Dock
connector developed to use with iPods. You may
require one of the enclosed Dock Adapters to
use with your iPod to ensure correct alignment
with the hi-fi system. To avoid possible damage
to your iPod, do not use your iPod with the prod-
uct with out the correct adapter fitted to the hi-fi
system.
1
Press » « on the iPod compartment lid to
open it.
2 Place the iPod adapter on the tray of the iPod.
3
Insert the iPod carefully into the »
iPod dock
«
connector (under the iPod compartment lid )
until it latches into place.
Connecting the headphones
1
Insert the headphone plug (ø 3.5 mm) into
the »
U
« socket (under the front flap) on the
front side of the hi-fi system.
– The loudspeakers of the hi-fi system are
switched off.
Note:
7
Excessive sound pressure from the ear-
phones or headphones can cause hearing
loss.
CONNECTION AND PREPARATION
---------------------------------------
Inserting a memory card
The hi-fi system supports SD/SDHC and MMC
memory cards.
Note:
7
The hi-fi system must be switched off while
the memory card is being inserted. If it is not
switched off, data can be lost.
1
Switch off the hi-fi system by pressing »
8
«.
2
Insert the card carefully into the »
SD
« card slot
(under the front flap) until it latches into place.
Note:
7
Do not use excessive force when inserting the
memory card. Only apply slight pressure.
7
The memory cards are resistant to dirt and
moisture, but may only be inserted into the
hi-fi system in a dry and clean condition.
7
Never remove memory cards during opera-
tion. This can damage the memory card.
This type of damage will invalidate your
warranty.
Removing the memory card
Note:
7
The hi-fi system must be switched off while
the memory card is being removed. If it is
not switched off, data can be lost.
1
Remove the memory card from the card slot by
pressing the card inwards slightly until the latch
is released. Then pull out the card.
