E 10210 12 - 2005
Protocols:
MODULAR X6 CCTALK VALIDATOR 30
Each solenoid is activated for 500 ms. if the corresponding bit is at “1”. The ACK reply of the
Validator is produced after the end of the command, 2 seconds maximum in depends of the
number of solenoids to activate. Each solenoid is activate sequentially if several are requested.
Command protected by a PIN.
Notes:
a)
A NACK is returned if:
The Exit module does not have its software correctly loaded.
The argument: [Data 1] is greater than 16 (0x0F).
There is a coin inside or the Validator is activating the exits or the solenoids at the
moment of reception of the command.
b)
There should be a visual or sound check that the corresponding mechanism activates
and deactivates.
Example:
The Machine requests Validator 2 to carry out a test of the acceptance gate solenoid and
solenoid 1 of the sorter.
Send: [2] [1] [1] [240] [3] [9]
Reply: [1] [0] [2] [0] [253] after 1 sec. (500 ms. each solenoid)
Note: Check visually that the path of acceptance opens and it moves the sorter.
5.15
READ INPUT LINES [237]
This command is only available if the Validator is programmed in “L66 compatibility” mode.
The L66-cctalk validator returns the switches status and the string detector mechanism.
Send:
[Dir] [0] [1] [237] [Chk]
Reply:
[1] [1] [Dir] [0] [Data 1] [Chk] -> ACK with a data
