E 10210 12 - 2005
Protocols:
MODULAR X6 CCTALK VALIDATOR 51
Command protected by a PIN. The response time is 5 mseg. approximately
Notes:
a)
A NACK is returned if:
The Exit module does not have its software correctly loaded
It is requested to write data out of the user zone or the number of bytes to write is 0.
If an error has occurred while the Flash memory is programmed.
b)
This command is not available if the Validator is working in “Secure Mode”.
5.32
REQUEST OPTION FLAGS [213]
This command is not available if the Validator is programmed in “L66 compatibility” mode.
Using this command the Validator informs the Machine how to send the coin values:
Send:
[Dir] [0] [1] [213] [Chk]
Reply:
[1] [1] [Dir] [0] [Data 1] [Chk] -> ACK with a data
Where
Dir = address of the corresponding validator
Data 1 = 0: the coin is indicated as “position of coin”
The codes of transmitted coins correspond to the position that they occupy in the memory of
the Validator. Each code corresponds with the position indicated in the inhibit bits (see
commands REQUEST COIN POSITION [212], and REQUEST INHIBIT STATUS [230]).
Command protected by a PIN.
Notes:
a)
A NACK is returned if the Exit module does not have its software correctly loaded.
b)
The Validator does not answer if it is programmed in “L66 compatibility” mode.
5.33
REQUEST COIN POSITION [212]
This command is not available if the Validator is programmed in “L66 compatibility” mode.
