E 10210 12 - 2005
Protocols:
MODULAR X6 CCTALK VALIDATOR 61
a)
The checksum only includes the programme area of the Exit module. The tables and
data programming are not included. In consequence, any modification of the tables in
the Validator or of the data does not modify the checksum calculated.
b)
The Validator does not answer if it is programmed in “L66 compatibility” mode.
5.41
REQUEST CREATION DATE [196]
This command is not available if the Validator is programmed in “L66 compatibility” mode.
This command requests the Validator for information about the creation date of the
programming of the coin tables of the Validator:
Send:
[Dir] [0] [1] [196] [Chk]
Reply:
[1] [2] [Dir] [0] [Data 1] [Data 2] [Chk] -> ACK with 2 data
Where
Dir = address of the corresponding validator
Data 1 = LSB of the date.
Data 2= MSB of the date.
The format of the date is indicated in Table 10:
Table 10: Date format
FORMAT of the DATE
Bit 15
Bit 14 Bit 13
Bit 9 Bit 8
Bit 5 Bit 4
Bit 0
Reserved Year
Month
Date
Relative to the base
year
1 to 12
1 to 31
The base year is executed in the command REQUEST BASE YEAR [170]. The value of the year
sent is the difference between the year the programming was created and the base year.
Command protected by a PIN.
Notes:
a)
A NACK is returned if
