E 10210 12 - 2005
Protocols:
MODULAR X6 CCTALK VALIDATOR 70
The modification of the level of security or band of admission is carried out gradually indicating
to the Validator how much it should increase or decrease the present level of security. It is
necessary to take into consideration the following:
-
The value 0 indicates to the Validator that the band of acceptance is “Normal Band”.
-
If when increasing security a value superior to 2 is reached, super narrow band, the
Validator takes the value 2.
-
If when decreasing security a value inferior to -1 is reached, wide band, the Validator
takes the value -1.
This information will be stored in the Flash memory of the Validator:
Command protected by a PIN.
Notes:
a)
A NACK is returned if:
-
The Exit module does not have its software correctly loaded
-
The Exit module does not have its tables correctly programmed.
-
It has received an incorrect coin code
-
There has been an error to the programming of the Flash memory of the Validator.
b)
This command is not available if the Validator is working in “Secure Mode”.
5.51
REQUEST SECURITY SETTING [180]
Command not available in “Secure Mode”.
The Machine requests the Validator for information about the type of band of acceptance or
level of security with which the Validator is working for a determined coin:
Send:
[Dir] [1] [1] [180] [Data 1] [Chk]
Reply:
[1] [1] [Dir] [0] [Data 2] [Chk] -> ACK with a data
Where
Dir = address of the corresponding validator
Data 1 Position of the coin (1 to 16)
