E 10210 12 - 2005
Protocols:
MODULAR X6 CCTALK VALIDATOR 73
This command requests the Validator for information about the number of times that an alarm
situation has occurred in the validator.
Send:
[Dir] [0] [1] [176] [Chk]
Reply:
[1] [1] [Dir] [0] [Data 1] [Chk]
-> ACK with a data
Where
Dir = address of the corresponding validator
Data 1 = 0 – 255: Counter of the number of alarms generated from the last
consult
The events defined as alarms are the following:
- Coin exit detectors continually covered.
- Measurement detectors continually covered.
- Coin rejected by the string detector system.
- Valid coin remains in the exit sensor for an excessive time.
- Valid coin does not reach the exit sensor.
- Valid coin reaches the exit sensor too soon.
The counter is kept in RAM and is reset each time the counter is read and after any reset or
power-up.
Command protected by a PIN.
Notes:
a)
A NACK is returned if the Exit module does not have its software correctly loaded
b)
The Validator does not answer if it is programmed in “L66 compatibility” mode.
5.55
REQUEST BASE YEAR [170]
This command is not available if the Validator is programmed in “L66 compatibility” mode.
