E 10210 12 - 2005
Protocols:
MODULAR X6 CCTALK VALIDATOR 75
The validator returns the value 132 (decimal) = 0x84 (hexadecimal) = 1000.0100 (binary)
Command protected by a PIN.
5.57
MODIFY INHIBIT AND OVERRIDE REGISTER [162]
This command is not available if the Validator is programmed in “L66 compatibility” mode.
This command permits the Machine to transmit information about the “present coin” and the
“following coin” defined by each of its inhibit masks.
Send:
[Dir] [6] [1] [162] [Data 1] [Data 2] [Data 3] [Data 4] [Data 5]
[Data 6] [Chk]
Reply:
[1] [0] [Dir] [0] [Chk]
Where
Dir = address of the corresponding validator
Data 1 and Data 2: inhibit mask of the present coin.
Data 3: not used = 0.
Data 4 and Data 5: inhibit mask of the following coin.
Data 6: not used = 0.
If the “following coin” is always deactivated, the validator will only accept one coin at a time.
Command protected by a PIN.
Notes:
a)
A NACK is returned if the Exit module does not have its software correctly loaded.
b)
The Validator does not answer if it is programmed in “L66 compatibility” mode.
5.58
REQUEST FIRMWARE UPGRADE CAPABILITY [141]
This command is not available if the Validator is programmed in “L66 compatibility” mode.
Using this command the Validator informs the Machine where the firmware in the Validator is
stored:
