USER MANUAL
53
Notice:
1)
The lines should not be too close to the edges of the picture or the detection may fail to trigger
the alarm when a target cross through it.
2)
The lines should be in an area that the detected object reach.
3)
The lines should not be too short or the detection may fail to trigger the alarm when a target
passes through it.
Channel
: Select the channel you want to configure
Buzzer
: Disable or enable the buzzer’s alarm tone. Can be set to 10, 20, 40 or 60 seconds when
the detection is triggered
Alarm Out
: If your DVR supports a connection to an external alarm device, you can set it to emit
an alarm tone.
Latch Time
: Set the duration of the external alarm when the detection is triggered.
Record:
Select the channel(s) you want to record when the detection is triggered.
Post Recording
: You can set how long the DVR will continue to record after an event has
occurred.
Show Message
:
A letter “S” will be displayed on the screen when the intelligent detection is
triggered.
Send Email:
If an alarm is triggered, an Email will be sent to your preset email account.
Full Screen:
When the detection is triggered, the channel will enlarge to full screen.
FTP Picture Upload:
If an alarm is triggered, a Picture will be sent to your preset FTP account.
FTP Video Upload:
If an alarm is triggered, a Video will be sent to your preset FTP account.
Picture to Cloud:
If an alarm is triggered, a Picture will be sent to your preset Cloud account.
Video to Cloud:
If an alarm is triggered, a Video will be sent to your preset Cloud account.
Alarm
: Click
for the parameter settings