GSC Golf Skate Caddy, Owner'S Manual

Page 16.

You can hear a beeping alarm coming 

from the Controller.

This just means the 9v battery in the 

remote is flat and need replacing.

The speed of your GSC™ is not stable 

or consistent.

Wireless Controller needs to be re-linked.  Turn both the Controller and 

GSC™ OFF. Wait 10 seconds, and turn them both back ON.

Check the battery in the Controller and replace if necessary.

If the problem is not resolved, contact GSC™ Customer Support and we’ll 

work to fix the issue.
Controller and GSC™ receiver are wet 

or moist.

Drain, and allow to thoroughly dry 

out. If damaged beyond repair, some 

components will need replacement.

I can’t charge my GSC™!

Either the charger or the battery is at 

fault. 

Here’s how to quickly find out which one is at fault: Check if the battery has any 

charge by running it in your GSC™.  No go? Reconnect the charger to your battery.  

If the light remains GREEN, you will know the charger is not working.  Replace the 

charger.
GSC™ is not charged, but charger 

always reads GREEN when plugged in.

Replace the charger

Strong vibration or loud high-pitched 

noise while riding.

Drive Belt is loose, or has worn out.  

Check if all wheels are smooth to turn, 

pumped up, if the drive wheel does not 

feel like it turns with even pressure in a 

full rotation, a stone, wood, debri may 

be inside the belt housing, remove the 

drive wheel check for anything while 

turning the drive wheel, remove, clean, 

check for damage on the teeth of the 

drive belt and sprockets.

To adjust the belt: Remove the drive wheel.  Loosen the 4 bolts that attach the 

Drive Belt housing cover and motor to the rear axle on the truck.  Pushing the 

motor and rear axle apart, begin tightening the four bolts.  The idea is to spread the 

two sprockets apart, as far as possible, so the belt will be tight.  The adjustment will 

only be about 2mm.  It doesn’t sound like much, but the Drive Belt must be as tight 

as possible between the sprockets for reliable performance.  Use a little Loctite 

(blue medium strength thread locker) on the nuts, and get them nice and tight.  Tip: 

If you like to ride hard, make a regular check on Drive Belt tension, and beat the 

problem before it happens.