8. 16"-24" Head Platform Assembly
PNEG-1807CE
CE Compliant 16"-24" Bucket Elevator Platform and Ladder “X” Series
65
Install Intermediate Handrails
IMPORTANT:
Trim each rail as listed. Do NOT attempt to make entire adjustment by trimming only one
rail. Each rail must be trimmed and installed as stated for proper fit.
IMPORTANT:
For safety purposes, make sure head of bolt is to the inside of platform with nuts on outside
at all connections.
1. Identify and separate the large and small intermediate handrails.
NOTE:
The small intermediate handrail (LDR-4088) fits inside of the large intermediate handrail.
It is critical that large and small rails be properly identified in advance. Rails are cut to
size and cutting the wrong rail or to the wrong length will prevent proper installation.
Figure 8R Intermediate Handrails
Ref #
Part #
Description
A
LDR-4088
Small Intermediate Handrail
B
S-6606
5/16" x 3/4" Flange Bolt
C
S-10268
5/16" Hex Flange Nut
D
LDR-4087
Large Intermediate Handrail
E
Hatch side large intermediate handrail needs to be at
location of latch.
F
Cut 4" off of each intermediate large and small rail so
the remaining length for each is 32".
G
Cut 15" off of each intermediate large and small rail so
the remaining length for each is 21".
H
Cut 4" off of each intermediate large and small rail so
the remaining length for each is 32".
Intermediate Handrails