PNEG-1461
12' and 15' Bulk Feed Tank Series and Grain Hopper Tank Series
13
4. General Information
Bulk Feed Tank Assembly Manual General Instructions
This product is intended for the use of storing feed only. Any other use is a misuse of the product.
While every effort has been made to keep the edges from being sharp, please wear the proper protective
clothing while erecting the Bulk Feed Tank.
Our company recommends that you contact the local power company and have a representative review
the installation so the wiring will be compatible with their system and so that you will have adequate power
supplied to the unit.
A Bulk Feed Tank weighs a minimum of 444 lbs. (201 kg). All precautions should be taken when raising
the tank to its feet. Follow the instructions given later in this manual.
The safety pages show you where you can find the safety decals. The photographs show exactly
where the decals should be. If a decal has been damaged or is missing contact our company for a
free replacement.
First, read the assembly manual completely before starting to assemble the Bulk Feed Tank. Check the
shipment with the packing list to be sure there are no shortages.
1. Decal protective mask must be removed when assembling tank. Mask may become difficult to
remove if left exposed to sunlight.
2. Vertical seams
must be staggered
on all sidewall rings.
3. When legs extend up 2 rings, the leg holes must be in
alignment
in the bottom 2 rings.
4. All hopper seams and the hopper collar use truss head bolts. The heads of the bolts must be on the
inside
of the tank.
5. Hex head bin bolts are used on all sidewall and roof seams with the bolt heads on the
outside
of
the bin.
6. Hex head bolts are to be used on all leg to sidewall connections with the bolt heads on the inside of
the tank.
7. All bolts are to be tightened from the
nut side only. Do not allow bolt heads to spin.
8. Drift punches can be used to align holes.
9. All vertical sidewall sheet seams must be overlapped in the same direction.
10. A hole spacing of 3-1/8" is used at the top of all top sidewall sheets and at the bottom of all bottom
sidewall sheets.
