Performing Pre–Start Checks
CAUTION
Failure to perform any or all of these pre-start checks may cause damage to the
equipment and/or cause SERIOUS INJURY or DEATH to those in the work area.
Failure to perform any or all of these pre-start checks may also be a misuse of the
equipment. Any misuse of the equipment may void the warranty.
1. Make sure ALL belts are tensioned properly.
2. Make sure ALL shields are in place and that the belt(s) and pulley(s) are able to move freely.
DANGER
ALWAYS keep ALL guards and shields in place, until all the power is
disconnected and locked out.
3. Inspect the drive unit for any problems or potential problems.
4. Be aware of any emergency shut down procedures. Two people must always be in a position where
the operation of the equipment can be monitored.
5. Before starting the auger for the first time, make sure that all parts are assembled correctly
according to the instructions in this manual.
CAUTION
Make certain ONLY trained operators are in the work area before operating or
moving the machine. Two (2) people must always be in a position where the
operation of the equipment can be monitored.
52
PNEG-2108
8" and 10" Standard Duty and IW Standard Duty
