* Press the " Button " will show " Relay8 action "
▲
screen as :
Relay8:Action
(0):N , (1):Y
@ It is to select if the Relay 8 will do action or no.
@ Typically always select to 1 ( Yes ).
* After finish to set the desired IM function., should
press the " ENTER " button.
* Before finish the " IM " setting, it should press
" SETUP Button " to return SETUP SCREEN.
1:AD 2:IO 3: TEL
SETUP SCREEN
4:RP 5:IM 6:SAVE
Then key in " 6 " ( SAVE ), LCD will show :
Save OK!
SETUP->Exit
7-6 SAVE
* After the system are already change the data,
value, function..., it should press " SETUP Button "
to return SETUP SCREEN.
1:AD 2:IO 3: TEL
SETUP SCREEN
4:RP 5:IM 6:SAVE
Then key in " 6 " ( SAVE ), LCD will show :
Save OK!
SETUP->Exit
@ The setting procedures are finished completely, the
change data, value and the function will be saved
'into the memory circuit.
21
