32
Take off radiator lid .
Connect Out-water line and fix it tightly
In pouring cooling liquid till it is full.
Carries on pumping air according to the following main point:
1 starts the vehicle, carries on high speed on the smooth road, at least 200 meters.
2 stops and checks foam whether vanishes, as well as liquid surface water level is
whether steady,
3 do the vehicle the system closure, pours into the radiator liquid, until
the radiator this note population border is Stops.
4 fix radiator lid
5 checks enough water in sluice bottle.
Function Inspection
Radiator Lid
Put lid on is inspector and it is good that keep on SIX seconds under standard pressure.
Standard pressure of Radiator lid valve:
73.5-103Kpa
Radiator Inspection
Connect Inspector and radiator, add air and it is good that keep on SIX seconds under standard
pressure.
Standard pressure
：
73.5-103 Kpa
Important!
Before take off radiator lid please
make sure that cooling liquid is NOT HOT.
NOICE!
Before checking please put some water on lid
airproof surface.
Important! Do not use too high pressure;
otherwise radiator will be destroyed on
condition of high pressure.
Out-water line
Radiator Inspector
Radiator Lid
Sluice bottle
