GPS/GLONASS Trip Meter
GT
1000C
6
The odometric functions of the Trip Meter utilise GPS and GLONASS technology
and, given good satellite coverage, achieve greater than 99% accuracy. The
number of satellites currently tracked by the device is shown in the lower-right
corner of the display; while four is the minimum number required to obtain
speed readings, seven to ten is typical.
Reset Trip B
Resets trip B to zero.
Current Position
Displays the vehicle’s current latitude
and longitude. Press
Menu
to return to
the menu. Change the displayed units
using the Setup Menu.
Trip A Dir
Sets the direction of trip A. Press
Enter
to cycle between
Up
,
Down
or
Select
.
Select
enables the use of the
arrow keys
to change direction
from the main display.
Trip B Dir
As above, but for trip B.
Average Based On:
Set the trip on which to base average
speed. Press
Enter
to toggle between
trip A and trip B.
Show Statistics
Display detailed trip information. Press
Menu
to return to the menu.
Preload Trips
Allows the user to preload either trip A
or trip B.
Main Display
The main display shows the two trip counters, satellite count, current
and average speed. The
arrow keys
select the direction of trip A or B if
set to do so in the configuration menu (see below).
Main Menu
