- 31 -
HDTA 614 T ASI
• Use
to position the cursor under the digit to be set for the symbol rate
displayed.
• Press
to enter the respective digit of the symbol rate needed.
• Repeat the procedure by the quantity of the digits to be set.
DVB mode:
The cassette recognizes the transmitted DVB mode and switches over between
the normal QPSK mode (DVB-S) and the DVB-S2 mode.
• Press the
button.
—> The "Input frequency" – "
FREQ
" submenu is activated.
i
nPut
frequenCy
—> This menu is only displayed if "Tuner" is selected as input signal
If three dots "
…
" appear in the second line of the display, the cassette is in
the "
station search
" mode. Please wait until the process has finished.
Once the RF receiver has synchronised to the input signal, any offset to the
target frequency is displayed in MHz, e.g. "
– 1.8
".
If a question mark "
?
" appears in the second line of the display, there is no
input signal present. In this case check the configuration of the antenna system
and head-end station as well as the preceding settings of the cassette.
FREQ
CN 9
Bx 4A
11835 +0.7
• Use
to position the cursor under the digit of the frequency displayed
to be set.
• Press
to set the respective digit of the input frequency needed.
• Repeat the procedure by the quantity of the digits to be set.
• Set the frequency offset shown in the display (e.g. "
– 1.8
") to less than
1 MHz ("
± 0.x
") by varying the input frequency using the
buttons.
