- 13 -
HDTA 614 T ASI
3.5 r
etrofit ting
a
Ca
module
The cassette is equipped with two common interfaces. This allows you to con-
nect two CA modules for various scrambling systems and service providers.
Scrambled channels can only be descrambled with a CA module suitable for
the scrambling system and the corresponding smart card. The smart card con-
tains all the information for authorisation, descrambling and subscription.
Caution
– Check with the distributor or manufacturer of the CA modules to be used
to ensure that they are suitable for descrambling several channels.
– The hardware and software of this cassette have been thoroughly prepared
and tested.
– Any changes made by programme provider to the structures in the pro-
gramme data might impair or even prevent this function.
– When working with the CA modules, please read the corresponding oper-
ating manuals from the respective providers.
• Insert the smart cards into the CA modules so that the chip
3
on the smart
card
1
faces the thicker side (top) of the CA module
2
.
• Insert the CA modules into the slots
4
with the top sides of the CA modules
in left direction.
• Push the CA modules without canting into the guide rails of the CA slots
4
and contact them to the common interfaces.
3
4
1
2
—> If the module is inserted in the head-end station, the left common
interface is assigned to tuner A, the right one to tuner C.
